DrayTek Router Radius Setup

ข้อมูลจำเพาะผลิตภัณฑ์

• ชื่อสินค้า : RADIUS Setup
• การทำงาน: Remote Authentication Dial-In User Service (RADIUS) client/server protocol
• การใช้งาน: Authenticating and authorizing dial-up and tunnelled network users

คำแนะนำการใช้ผลิตภัณฑ์

การแนะนำ:
Remote Authentication Dial-In User Service (RADIUS) is a security authentication client/server protocol widely used by Internet service providers for remote access services. It is commonly used for authenticating and authorizing dial-up and tunnelled network users.

การกำหนดค่า:
Follow the steps below to configure the RADIUS client function:

1. Check the Enable box to activate the RADIUS client function.
2. Server IP Address: Enter the IP address of the RADIUS Kserver.
3. Destination Port: Specify the UDP port number on which the RADIUS server is listening. The default value is 1812 based on RF 2138.
4. Shared Secret: Configure a shared secret between the RADIUS server and client for message authentication.
5. Re-type Shared Secret: Confirm the Shared Secret by retyping it.

การแนะนำ

• Remote Authentication Dial-In User Service (RADIUS) is a security authentication client/server protocol widely used by Internet service providers for other remote access services. RADIUS is the most common means of authenticating and authorizing dial-up and tunnelled network users.
• The built-in RADIUS client function allows you to extend the remote dial-in user accounts to the RADIUS server. Your user accounts will not be limited by built-in accounts. It also lets you centralize remote access authentication for network management.

การกำหนดค่า

• Check the Enable box to enable the RADIUS client function
• ที่อยู่ IP ของเซิร์ฟเวอร์: The IP address of the RADIUS server
• พอร์ตปลายทาง: The UDP port number on which the RADIUS server is listening. The default value of 1812 is based on RFC 2138.
• ความลับที่ใช้ร่วมกัน: The RADIUS server and client share a secret that is used to authenticate the messages sent between them. You must configure both sides to use the same shared secret.
• Re-type Shared Secret: Confirm the Shared Secret.

คำถามที่พบบ่อย

What is RADIUS used for?

RADIUS is used for authenticating and authorizing dial-up and tunnelled network users in a centralized manner.

How do I configure the RADIUS client function?

To configure the RADIUS client function, enable it, provide the RADIUS server IP address, specify the destination port, set up a shared secret, and confirm the shared secret.

เอกสาร / แหล่งข้อมูล

DrayTek Router Radius Setup [พีดีเอฟ] คำแนะนำ Router Radius Setup, Radius Setup

อ้างอิง

• คู่มือการใช้งาน