1. สินค้าหมดview
The Sicce Ultrazero Flat Sucking Pump is designed for efficient removal of water from various areas, including flooded cellars, garages, and other spaces where minimal residual water is desired. This submersible pump is capable of reducing water levels down to 2-3 mm.
คุณสมบัติหลัก:
- Capable of pumping water down to 2 mm residual level.
- Fully submersible design.
- Handles dirt particles up to 3 mm in size.
- มาพร้อมสายไฟยาว 10 เมตร
- Features a practical carry handle for easy transport.

รูปที่ 1: เกินview of the Sicce Ultrazero Flat Sucking Pump.
2. ข้อมูลด้านความปลอดภัย
Read all safety warnings and instructions before operating the pump. Failure to follow these instructions may result in electric shock, fire, or serious injury.
- Always disconnect the pump from the power supply before handling, cleaning, or performing any maintenance.
- ตรวจสอบแหล่งจ่ายไฟ voltage matches the pump's specifications (230 V/50 Hz).
- Do not operate the pump with a damaged power cord or plug. If damaged, it must be replaced by the manufacturer, service agent, or similarly qualified persons to avoid a hazard.
- Do not use the pump to handle flammable or explosive liquids.
- ให้เด็กและบุคคลที่ไม่ได้รับอนุญาตอยู่ห่างจากพื้นที่ปฏิบัติงาน
- ตรวจสอบให้แน่ใจว่าปั๊มจมอยู่ในน้ำอย่างสมบูรณ์ขณะใช้งานเพื่อป้องกันความร้อนสูงเกินไป
- Avoid running the pump dry for extended periods.
- This pump is designed for water only. Do not use it for other liquids without consulting the manufacturer.
3. การตั้งค่าและการติดตั้ง
Follow these steps to properly set up your Ultrazero pump:
- แกะปั๊มออก: นำปั๊มและอุปกรณ์เสริมทั้งหมดออกจากบรรจุภัณฑ์อย่างระมัดระวัง ตรวจสอบความเสียหายที่อาจเกิดขึ้น
- Connect the Discharge Hose:
The pump features a 26.44 mm (3/4") AG pressure connection. Attach a suitable discharge hose (e.g., 20 mm (3/4") hose connection) to this outlet. Ensure the connection is secure to prevent leaks.

Figure 2: Close-up of the pump's discharge outlet and integrated carry handle.
- ตำแหน่งปั๊ม: Place the pump directly on the surface from which water needs to be removed. Ensure the pump is stable and upright. The flat base allows for efficient water removal down to minimal levels.
- Route the Discharge Hose: Direct the discharge hose to a suitable drainage area, ensuring the water will not flow back into the area being drained.
- การเชื่อมต่อไฟฟ้า: Plug the 10-meter power cable into a grounded 230 V/50 Hz electrical outlet. Ensure the outlet is protected by a Ground Fault Circuit Interrupter (GFCI) for added safety, especially in wet environments.

Figure 3: The flat base of the pump designed for low residual water levels.
4. คู่มือการใช้งาน
The Ultrazero pump is designed for simple operation:
- จุ่มปั๊ม: Ensure the pump is fully submerged in the water you wish to remove. The pump requires water to cool its motor and operate correctly.
- เริ่มสูบน้ำ: Once submerged and connected to power, the pump will begin operating automatically. It does not feature a float switch, so manual monitoring is required for optimal use.
- ตรวจสอบระดับน้ำ: The pump will continue to operate until the water level reaches its minimum suction capability of 2-3 mm.
- หยุดสูบน้ำ: To stop the pump, disconnect it from the power supply. It is recommended to disconnect the pump once the desired water level is reached or if the pump starts to run dry.

Figure 4: The Ultrazero pump effectively draining water from a small pool.

Figure 5: The pump in action on a flooded floor, demonstrating its low-level suction capability.

Figure 6: Illustration of the pump's ability to reduce water levels to approximately 2 mm.
5. การบำรุงรักษา
การบำรุงรักษาอย่างสม่ำเสมอจะช่วยให้ปั๊มของคุณมีอายุการใช้งานยาวนานและทำงานได้อย่างมีประสิทธิภาพสูงสุด
- การทำความสะอาด: After each use, especially when pumping dirty water, rinse the pump thoroughly with clean water. This helps prevent sediment buildup.
- ตรวจสอบเศษซาก: Periodically check the pump's intake area for any debris (e.g., leaves, small stones) that might obstruct water flow. Remove any blockages carefully after disconnecting power.
- การตรวจสอบสายเคเบิล: Regularly inspect the power cable for cuts, abrasions, or other damage. Do not use the pump if the cable is damaged.
- พื้นที่จัดเก็บ: When not in use, store the pump in a clean, dry place, protected from frost.

Figure 7: The pump can also be used for transferring water for tasks like garden watering from a rain barrel.
6 การแก้ไขปัญหา
If you encounter issues with your Ultrazero pump, refer to the following common problems and solutions:
| ปัญหา | สาเหตุที่เป็นไปได้ | สารละลาย |
|---|---|---|
| ปั๊มไม่เริ่มทำงาน | ไม่มีแหล่งจ่ายไฟ สายไฟเสียหาย ระบบป้องกันมอเตอร์โอเวอร์โหลดทำงานแล้ว | ตรวจสอบการเชื่อมต่อสายไฟและเต้าเสียบ Inspect cable for damage; replace if necessary (by qualified personnel). Disconnect power, allow motor to cool, then reconnect. |
| ปั๊มน้ำทำงานแต่ไม่มีน้ำออก | Intake blocked. สายยางระบายน้ำบิดงอหรืออุดตัน Airlock in pump. | Disconnect power, clear intake. Check and clear discharge hose. Briefly lift and lower the pump while submerged to release trapped air. |
| ประสิทธิภาพการสูบน้ำลดลง | การอุดตันบางส่วน Impeller worn. | Disconnect power, clean pump intake and impeller area. ติดต่อฝ่ายสนับสนุนลูกค้าเพื่อรับบริการ |
| ปั๊มหยุดโดยไม่คาดคิด | Overheating due to low water level or blockage. ไฟฟ้าขัดข้อง. | Disconnect power, check water level and clear blockages. Allow to cool. หากปัญหายังคงมีอยู่ โปรดติดต่อฝ่ายสนับสนุนลูกค้า |
If the problem persists after attempting these solutions, please contact Sicce customer support.
7. ข้อมูลจำเพาะทางเทคนิค
Detailed specifications for the Sicce Ultrazero Flat Sucking Pump, Model 925607:
| ข้อมูลจำเพาะ | ค่า |
|---|---|
| ยี่ห้อ | ซิคเซ่ |
| หมายเลขรุ่น | 925607 |
| Max. Delivery Rate (Flow Rate) | 3000 ลิตร/ชม. |
| สูงสุด ความสูงในการจัดส่ง | 3.1 เมตร |
| Power Consumption (P1) | 80 วัตต์ |
| ปฏิบัติการฉบับที่tage | 220-240 โวลต์ / 50 เฮิรตซ์ |
| Conductor Length (Power Cable) | 10 m (three-core, indoor and outdoor use) |
| การเชื่อมต่อแรงดัน | 26.44 mm (3/4") AG |
| Hose Connection Diameter | 20 มม. (3/4 นิ้ว) |
| Max. Solids Size | 3 มม. |
| ระดับน้ำตกค้าง | Down to 2-3 mm |
| ขนาดสินค้า (โดยประมาณ) | 140 mm (Diameter) x 160 mm (Height) / 5.5" x 6.3" |
| น้ำหนักสินค้า | 2.6 กก. (5.72 ปอนด์) |
| สวิตช์ลูกลอย | เลขที่ |
| ระบบป้องกันการโอเวอร์โหลด | No (Internal thermal protection may exist, but no external reset) |
| ต้นทาง | ผลิตในประเทศอิตาลี |

Figure 8: Technical drawing illustrating the pump's dimensions and 3/4" GAS connection.
8. การรับประกันและการสนับสนุน
For warranty information or technical support regarding your Sicce Ultrazero Flat Sucking Pump, please contact Sicce customer service. Keep your purchase receipt and model number (925607) handy when contacting support.
ผู้ผลิต: เอบาร่า
ยี่ห้อ: ซิคเซ่
For further assistance, visit the official Sicce webไซต์หรือติดต่อตัวแทนจำหน่ายในพื้นที่ของคุณ





