LASCO 24V Heat Only Thermostat

White Rodgers 24V Heat Only Thermostat Instruction Manual

Model: 24V Heat Only Thermostat

1. บทนำ

This manual provides comprehensive instructions for the installation, operation, and maintenance of your White Rodgers 24V Heat Only Thermostat. This device is designed to control heating systems by maintaining a desired temperature within a range of 50 to 90 degrees Fahrenheit (10 to 32 degrees Celsius). Please read these instructions carefully before proceeding with installation or operation to ensure safe and efficient use.

2. ข้อมูลด้านความปลอดภัย

ปฏิบัติตามข้อควรระวังเพื่อความปลอดภัยต่อไปนี้เสมอ:

  • อันตรายจากไฟฟ้า: Disconnect power to the heating system at the main fuse or circuit breaker panel before installing or servicing the thermostat. Failure to do so may result in electrical shock or equipment damage.
  • เล่มที่tagความเข้ากันได้: This thermostat is designed for 24V heating systems only. Do not use it with line voltage (120V or 240V) systems.
  • การติดตั้งโดยมืออาชีพ: If you are unfamiliar with electrical wiring, it is recommended to have a qualified electrician or HVAC technician install this thermostat.
  • การกำจัดที่ถูกต้อง: Dispose of old thermostats and packaging materials according to local regulations.

3. การติดตั้งและการตั้งค่า

ปฏิบัติตามขั้นตอนเหล่านี้เพื่อการติดตั้งที่ถูกต้อง:

3.1 ตำแหน่งการติดตั้ง

Install the thermostat on an inside wall, approximately 5 feet (1.5 meters) above the floor. Avoid locations:

  • Near windows, outside doors, or vents.
  • Near heat-generating appliances (e.g., televisions, lamps, refrigerators).
  • In direct sunlight or areas with poor air circulation.

3.2 การเดินสายไฟ

Before wiring, ensure power to the heating system is OFF.

  1. Remove the cover of the old thermostat and note the wire connections. Typically, a heat-only system will have two wires: 'R' (power) and 'W' (heat call).
  2. Disconnect the wires from the old thermostat.
  3. Mount the new White Rodgers thermostat base to the wall using the provided screws.
  4. Connect the 'R' wire to the 'R' terminal and the 'W' wire to the 'W' terminal on the new thermostat. Ensure connections are secure.
  5. เปลี่ยนฝาครอบเทอร์โมสตัท

3.3 การเพิ่มพลังเริ่มต้น

Restore power to the heating system at the main fuse or circuit breaker panel. The thermostat is now ready for operation.

White Rodgers Heat Only Thermostat with temperature dial and OFF/ON switch

รูปที่ 1: ด้านหน้า view of the White Rodgers Heat Only Thermostat. The upper slider controls the OFF/ON function, while the lower slider sets the desired temperature, indicated in both Fahrenheit (50-90) and Celsius (10-32).

4. คู่มือการใช้งาน

The White Rodgers Heat Only Thermostat features simple manual controls.

4.1 การควบคุมพลังงาน

The upper slider on the thermostat controls the power to the heating system:

  • เลื่อนไปที่ ปิด: Disables the heating system.
  • เลื่อนไปที่ ON: Enables the heating system to operate based on the set temperature.

4.2 การตั้งอุณหภูมิ

The lower slider on the thermostat is used to set your desired room temperature:

  1. Ensure the upper slider is set to ON.
  2. Move the lower slider to the desired temperature setting. The scale indicates temperatures in both Fahrenheit (50-90°F) and Celsius (10-32°C).
  3. The heating system will activate when the room temperature falls below your set point and will turn off when the room temperature reaches or exceeds your set point.

5. การบำรุงรักษา

This thermostat requires minimal maintenance.

  • การทำความสะอาด: ควรเช็ดทำความสะอาดภายนอกของเทอร์โมสตัทเป็นระยะด้วยผ้าเนื้อนุ่มและแห้งamp ผ้า ห้ามใช้สารทำความสะอาดที่มีฤทธิ์กัดกร่อนหรือตัวทำละลาย
  • การกำจัดฝุ่น: Gently remove any dust accumulation from the vents or internal components using a soft brush or compressed air. Ensure power is off before cleaning internal components.
  • This model does not require battery replacement as it is a mechanical, 24V wired thermostat.

6 การแก้ไขปัญหา

If you encounter issues with your thermostat, refer to the following table:

ปัญหาสาเหตุที่เป็นไปได้สารละลาย
ไม่มีความร้อน
  • Thermostat set to OFF.
  • ตั้งอุณหภูมิต่ำเกินไป
  • ฟิวส์ขาดหรือเบรกเกอร์สะดุด
  • สายไฟหลวม.
  • ระบบทำความร้อนทำงานผิดปกติ
  • Set thermostat to ON.
  • เพิ่มอุณหภูมิที่ตั้งไว้ให้สูงกว่าอุณหภูมิห้อง
  • Check and replace fuse or reset breaker.
  • Check wiring connections (ensure power is OFF).
  • Contact an HVAC technician.
การอ่านอุณหภูมิไม่แม่นยำ
  • ตำแหน่งเทอร์โมสตัทที่ได้รับผลกระทบจากลมโกรกหรือแหล่งความร้อน
  • ฝุ่นละอองสะสม
  • Relocate thermostat if possible, or shield from drafts/heat sources.
  • Clean thermostat (ensure power is OFF).
Heating system runs continuously
  • ตั้งเทอร์โมสตัทไว้สูงเกินไป
  • เทอร์โมสตัททำงานผิดปกติ
  • อุณหภูมิที่ตั้งไว้ต่ำกว่า
  • If problem persists, contact an HVAC technician.

7. ข้อมูลจำเพาะ

  • ยี่ห้อ: White Rodgers (Manufactured by LASCO)
  • แบบอย่าง: 24V Heat Only Thermostat
  • เล่มที่tage: 24 โวลต์
  • ปัจจุบัน: 1.2 Amps
  • ช่วงอุณหภูมิ: 50 ถึง 90°F (10 ถึง 32°C)
  • ประเภทจอภาพ: Manual Slider
  • ประเภทการควบคุม: Button Control (Slider)
  • แสงไฟด้านหลัง: เลขที่
  • ขนาด : Approximately 20 x 7 x 8.8 inches (Product packaging dimensions, actual unit smaller)
  • น้ำหนักสินค้า: 6.4 ออนซ์
  • ยูพีซี: 786710545658

8. การรับประกันและการสนับสนุน

Specific warranty information for this White Rodgers thermostat is not provided in the product details. For warranty claims or technical support, please refer to the contact information provided with your purchase or visit the official White Rodgers website. Keep your proof of purchase for any warranty-related inquiries.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.